DIS Support

Click on the category to browse FAQs.

CAN (29)

Knowledge of CANopen and CANopen Safety

CANS (7)
EDS files (7)

Common SDO commands for configuring CANopen sensors (transmit list attached)

Configure CANopen output with TPDO mapping parameters

EDS & DCF files

How can I configure a CAN sensor with my PC?

How can I reset a CAN sensor to the factory default setting?
General (27)

General questions about DIS products

News from product management (2)

4-20 mA current output Sensor

Can I buy sensors with a custom case?

Can I buy sensors with a different cable type, cable length and connector?

Can I buy sensors with a different range?

Can I buy sensors with different analogue output signal?
Product Features (35)

Product Features

Acceleration Sensors (2)
Configurators (10)
Inclination Sensors (2)
Rotary Encoders (9)
Tilt Switch (4)

Can I use a standard QG40N analog sensor for safety applications?

Do you have any sensor with PWM output?

Frequency Response

What can the RS232 RX and TX lines withstand?

What does -3dB mean in our datasheet?
Release Notes (10)

release notes of firmware updates etc.

Firmware release notes for sensor family: QG40N Analog AV/AI

Firmware release notes for sensor family: QG40N Tiltswitch

Firmware release notes for sensor family: QG40N Tiltswitch SIL1

Firmware release notes for sensor family: QG65N/QG76N CANopen (F-type)

Firmware release notes for sensor family: QG65N/QG76N CANopen Safety (D-type)
Sales related questions (1)

Sales related questions

What is the tarrif code for custom clearance?
Training videos (4)

Training videos of DIS products.

Customising DI outputs with function mode

PC application for DIS configurator set CAN

Unboxing and connecting DIS configurator set CAN

Unboxing and introduction QG65D dynamic inclinometers
Troubleshooting and Known Issues (6)

Known Issues

QG40N configuration software problems list

QG65D/N2-KDXYh-090H-CAN-CFM-UL - EMCY EEPROM Error message when "reset node" option is checked.

Sensor Defect Troubleshooting

The centering of a sensor fails. What could be wrong?

Why does my CAN safety sensor stop sending SRDO messages after restoring default parameters using Object 1011?

Please Wait!

Please wait... it will take a second!